![]() Please make sure the frame sticker is positioned correctly. But you can also remove the films right away. This prevents anything from sticking to the frame sticker before you install it. You can leave the small protective films on for now and remove them when you've connected the display and attached the bracket plates.You can use the plastic spudger to press the adhesive on. Make sure the frame sticker is positioned evenly and press it on. Position the frame sticker carefully on one edge of the frame and attach it gradually.Remove the first protective film layer of the frame sticker.To make sure that the new frame sticker will really stick, remove all glue residue and dirt from the metal frame.The iPhone Xs is built in the same way and is re-glued in the same way. Then carefully bend all flex cables to the side and remove the logic board.Then unlock the SIM card holder and take it out.They connect for example the charging socket, the flashlight and the volume keys. Then disconnect all other contacts from the logic board.If you can't get any further with a Spudger, you can also lever very carefully with tweezers or another thin tool. The contacts are very firmly connected to the logic board and are not easily accessible. ![]() Loosen the two contacts carefully with a spudger.Remove the Standoff screw and loosen the cover.There are also special screwdrivers with a cross profile and a pin in the middle. For the screw with internal thread, also called Standoff screw, you can use a thin slotted screwdriver. Two of the contacts on the logic board are still under a cover plate. Once all the adhesive strips are off, you can remove the battery.Try to bend the battery as little as possible.įirmly hold the battery and iPhone while pulling out the last adhesive strip to prevent the battery from falling out of the device. If one of the adhesive strips tears, you have to pry out the battery carefully using a wide Spudger. Make sure not to damage any flex cables at the bottom and top edge of the battery. How to do this is best seen in the video (play button in the upper right corner of the first picture). You can pull out the adhesive strips with your fingers or wrap them on the tweezers.Keep the strips as flat as possible at the level of the iPhone. Now pull out the adhesive strips very slowly.Underneath are the white adhesive strips. Use tweezers or a spatula to peel off the black tabs.Three tabs are glued to the bottom edge and one strip to the top edge of the battery. The adhesive strips have tabs to pull them out. The battery is glued to the case with four adhesive strips. Heat the outer edge of the frame several times if necessary. Rest the display on a stable object to avoid straining the sensitive flex cables. Then you can fold the display over to the side. Now use the pick to push up the display so the tabs disengage from the steel frame.Don’t stick the pick in too far on the side where the Sleep/Wake button is because that could damage the display flex cables. Because the display’s glued on all sides, you have to slide the pick all around the iPhone between the steelframe and the display frame.But change to a hard plastic plectrum as soon as possible to avoid scratches on the frame. If you can't get a plectrum into the gap, you can use an iFlex. While lifting the screen with the suction cup, insert the hard plastic pick between the steel frame and the display frame and press down the steel frame.ĭo not insert your tool more than 5 mm into the gap, so you don't damage small parts inside the iPhone. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |